5.
Use the u and i arrow buttons to enter or
exit the Duet Mode.
• Off: Disabled
On: Enabled (Both left and right keyboard sounds
are input from the left and right speakers.)
Pan: Enabled (Left side keyboard play is output from
the left speaker and right side play is output
from the right speaker. The Duet Pan Mode
effect is applied only while a grand piano tone is
selected.)
• Turning on layer (page EN-18) automatically exits the
Duet Mode.
6.
Press the SETTING button to exit the setting
screen.
• After you are finished using the Duet Mode, repeat
the above procedure from step 2 and select “Off” in
step 5. The Duet Mode is also exited by any one of the
operations below.
– Turning on layer (page EN-18)
• Note that Layer (page EN-18), Transpose (page
EN-22), and normal Octave Shift (page EN-24) cannot
be selected while duet is enabled. You can use the
procedure under “To change the octaves of the duet
keyboards” below to change the octaves of the duet
keyboards.
• The effects below are not applied while the DUET
PAN lamp is lit.
– Acoustic Simulator (except for Hammer Response
and Lid Simulator) (page EN-13)
– Hall Simulator (page EN-14)
– Chorus (page EN-15)
You can change the ranges of the left and right
keyboards in octave units from their initial default
settings.
1.
Press the SETTING button to display the
setting screen.
2.
Use the q and w arrow buttons to select
“Duet” and then press the ENTER button.
3.
Use the q and w arrow buttons to select a
keyboard range.
• Upper Octave: Right-side keyboard
Lower Octave: Left-side keyboard
4.
Use the u (–) and i (+) arrow buttons to
change the octave.
• +1 or higher: Raises the octave by the specified value.
–1 or lower: Lowers the octave by the specified value.
0: Returns the octave to its original setting.
• The setting range is –2 to +2.
• Example: To select “Lower Octave” in step 3 and set
“+1” in step 4
5.
Press the SETTING button to exit the setting
screen.
To change the octaves of the duet
keyboards
L o w e r O c t a v e
C4 C5 C6 C7 C3 C4 C5 C
To Next Page
Loading...
Need help?
General
