EN-18
Playing with Different Tones
Use the following procedure to layer two tones, so they
sound at the same time.
1.
Press the LAYER button.
2.
Use the u and i arrow buttons to display
“LAYER”.
3.
Select the main tone.
• Use the q and w arrow buttons to select “U1”
(Upper 1) and then press the ENTER button.
4.
Select a tone and then press the ENTER
button.
• See “Selecting and Playing a Tone” on page EN-10 for
information about how to select a tone.
5.
Select the layered tone.
• Use the q and w arrow buttons to select “U2”
(Upper 2) and then press the ENTER button.
6.
Select a tone and then press the ENTER
button.
7.
Press a keyboard key.
• Both tones sound at the same time.
8.
To cancel layering and switch to a single tone
(Upper 1), press the LAYER button or EXIT
button.
• Each press of the LAYER button toggles between
unlayered (one tone) and layered (two tones).
• Entering the Duet Mode (page EN-16) or Duet Pan
Mode will disable layering.
• Configuring of layering settings is not supported by
MIDI Recorder Track 2 recording.
1.
Hold down the LAYER button until the screen
shown below appears.
2.
Use the q and w arrow buttons to select
“Layer Balance”.
3.
Use the u (–) and i (+) arrow buttons to
adjust the layer volume balance.
• –1 or lower: Increases the Upper 1 tone volume.
+1 or higher: Increases the Upper 2 tone volume.
0: Upper 1 and Upper 2 volume the same.
• The setting range is –24 to +24.
4.
To return to the screen you were at prior to
step 1 of this procedure, press EXIT button.
Layering Two Tones
To Next Page
Loading...
Need help?
General
