You can use the procedure below to change the octave
of each layer.
1.
Hold down the LAYER button until the screen
shown below appears.
2.
Use the q and w arrow buttons to select
the layer whose octave you want to change.
• Upper 1: Select “Upper1 Octave”
Upper 2: Select “Upper2 Octave”.
3.
Use the u (–) and i (+) arrow buttons to
change the octave.
• +1 or higher: Raises the octave by the specified value.
–1 or lower: Lowers the octave by the specified value.
0: Returns the octave to its original setting.
• The setting range is –2 to +2.
4.
To return to the screen you were at prior to
step 1 of this procedure, press EXIT button.
You can use the procedure below to assign different
tones to the right range and left range of the keyboard,
so it sounds like you are playing an ensemble between
two instruments.
• If you turn on both layer and split, layering will be
applied to the right side range of the keyboard only.
• Use of the Duet Mode (page EN-16) is recommended
to divide the keyboard in the center between a left
keyboard and right keyboard of identical ranges.
1.
Press the LAYER button.
2.
Use the u and i buttons to display
“SPLIT”.
• To use both keyboard split and keyboard layering,
display “LAYER&SPLIT”.
3.
Select a tone for the left keyboard.
• Use the q and w arrow buttons to select “L”
(Lower) and then press the ENTER button.
4.
Select a tone and then press the ENTER
button.
• See “Selecting and Playing a Tone” on page EN-10 for
information about how to select a tone.
To change the octave of each layer
Splitting the Keyboard
between Two Different Tones
F
#
3
Acoustic Bass BERLIN GRAND
To Next Page
Loading...
Need help?
General
