• Select the tone and effects (Track 1 only) you want to
use in your recording.
Tone (page EN-10)
Effects (page EN-14)
1.
Hold down the REC button until the setting
screen shown below appears.
2.
Use the q and w arrow buttons to select
“Recorded Part”.
3.
Use the u and i arrow buttons to enable
(Play) or disable (Mute) of the recorded track.
4.
Press the REC button.
• “Rec Wait...” appears on the display indicating
record standby.
5.
Use the u and i arrow buttons to select
“MIDI REC”.
• If you want the metronome to sound while you are
recording, configure the beat and tempo settings, and
then press the METRONOME button. See “Using the
Metronome” on page EN-21 for more information.
6.
Use the REC button to select a track for
recording.
• L: Track 1
R: Track 2
• “L” and “R” indicate status information about the left
and right tracks as described below.
– If you selected “Play” in step 3, above:
Flashing: Track to be recorded.
Lit: Track to be played back.
– If you selected “Mute” in step 3, above:
Flashing: Track to be recorded.
Unlit: Track to be muted.
7.
Press the /k button or play something on
the keyboard.
• This will start both playback of the recorded track
and recording to the other track.
8.
To stop recording, press the /k button.
1.
Hold down the REC button until the setting
screen shown below appears.
2.
Use the q and w arrow buttons to select
“Precount”.
3.
Use the u and i arrow buttons to enable
(On) or disable (Off) the precount.
4.
Press the EXIT button to exit the setting
screen.
To record the other track of a song
To Next Page
Loading...
Need help?
General
