EN-60
Getting Ready
9.
First, use the two screws
to secure the
back of the piano (both left and right side) to
the stand. Next, use the two screws
to
secure the front of the piano (both left and
right side).
• If you have trouble insert the
screws, better align
the back of the piano unit and the stand side panels
(at the position marked in the illustration).
• The screws
keep the piano from slipping off the
stand. Never use the piano without the screws
installed.
10.
Affix the adaptor cord clip
next to the
power terminal (DC 24V).
Be sure to insert felt or other material between the
rubber feet and flooring. Do not allow direct contact
between them. Some types of flooring material may
become discolored or damaged by direct contact with
the rubber feet.
1.
Insert the plug of the AC adaptor that comes
with the Digital Piano into its power terminal
(DC 24V).
■ Using the Clip
• To fasten the clip
As shown in the illustration, press down on (a) to
force the tip of the clip into the slot. Press down until
you hear the clip click securely into place.
• To release the clip
As shown in the illustration, press (b) in the
direction indicated by the arrow.
Handling Precautions
To Next Page
Loading...
Need help?
General
