20110901
Transferring Data
This section explains data transfer operations while the ClassPad drive is open on a
computer.
To transfer data between ClassPad and a computer
(1) Establish a connection between the ClassPad and computer, and then open the
ClassPad drive on the computer.
• For details about how to establish a connection, see “To establish a connection
between the ClassPad and a computer” (page 2-5-1).
(2) Perform copy, edit, delete, and other file operations as required.
• Use the same file operations that you normally do on your computer.
• If you have a VCP file or XCP file you want to transfer to ClassPad, copy it to the
ClassPad drive.
(3) After you finish all the operations you want to perform, terminate the USB connection
between ClassPad and the computer.
• When you terminate a USB connection, ClassPad automatically imports a VCP file
currently in the AutoImport folder. For details, see “Auto Import of VCP Files” below.
• For information about manual file import, see “2-6 VCP and XCP File Operations”.
Note
Copying files to the ClassPad drive can cause the connection between the ClassPad and
computer to be dropped. If this happens, enter the System application and execute an
Optimize operation (page 1-8-1), and then re-establish a connection between the ClassPad
and computer.
k
u
2-5-3
Transferring Data between ClassPad and a Computer
To Next Page
Loading...
Need help?
General
