171
(3) Screen display when configuration failed
If configuration was unsuccessful, the details of the error are displayed in a message box.
The list of messages is described later.
(4) Screen display when reading was successful, with the /D option
(USA/EU/Japan)
The screen in (1) above is displayed, with ”Successfully finished” replaced by ”Current Settings”.
If the data is illegal, the display for “Country:” is “Undefined Code(xx)”.
xx indicates the set data.
(5) Screen display when reading was successful, with the /D option (custom)
The screen in (2) above is displayed, with ”Successfully finished” replaced by ”Current Settings”.
(6) Screen display when reading failed, with the /D option
If reading was unsuccessful, the details of the error are displayed in a message box.
The list of messages is described later.
- Termination status
This tool sets termination status on termination. Termination status can be referred to if the
program was started from a kitting tool or from a batch file.
Termination status is 0 if configuration succeeded.
Termination status is an error number if configuration failed (see error numbers below).
- List of error messages and error numbers
Error
No.
Error message Cause
1 The terminal is not supported. The terminal was not configurable
2 Failed to open the ini file. ini file opening error
3 The ini file is wrong. ini file is incomplete
4 Failed to establish the settings. Writing to the terminal failed
5 Failed to verify the settings. The data differs between writing and reading
6 Failed to retrieve the settings. Reading configuration values from within the
terminal failed
To Next Page
Loading...
