115
3.6 Laser Scanner (1D) Settings
This function only applies to models equipped with a laser scanner (1D).
Refer to Chapter 2, “2.9 Laser Scanner (Barcode)” for details of this function.
3.6.1 Laser Setting
Select Start -> Settings -> Control Panel - Scanner settings.
Use the tool below to change scanner device settings.
[Read barcode]Tab [Driver Mode]Tab
Tab Explanation
Read barcode Specify the 1D code to read.
Multiple symbologies can be specified.
Driver Mode
This tab is to set up “Enable” or “Disable” for 1D symbologies, and to
specify options.
- Min (No. of minimum readable digits)
- Max (No. of maximum readable digits)
- Output format
- Check-digit
- Check-digit output
To Next Page
Loading...
