Casio DT-X200 Series - Page 82

82
(8) Bluetooth power supply status
ⅰ Bluetooth power is turned on by the following operation.
This is the case if the BluetoothON operation was performed by a tool, and the BTLIB Initialize
function was called.
ⅱ Bluetooth power is turned off by the following operation.
This is the case if the BluetoothOFF operation was performed by a tool, and the BTLIB DeInitialize
function was called.
ⅲ Default state
- The power is off in the default state after a full reset.
ⅳ Operation on terminal reset
- WEC7: The power turns off. However, it is on if the tool selected on after the reset.
- WEH6.5: The power state which preceded the reset is restored.
ⅴ Processing during a terminal suspend and resume
- On suspend: The module power turns off.
- On resume: The power state which preceded the suspend is restored.