Casio DT-X200 Series Software Manual

87
(6) Multi SSID
The following method is available if it is necessary to connect to multiple different SSIDs.
i Manual switching
Prepare multiple configuration files (INI files), to switch the configuration file used on the
application site to match the SSID that is connected to.
Purpose of use
To move between multiple branches where each one has a different access point SSIS. In this
case, the SSID connected to before work is switched and used.
[Remarks] After switching the configuration file, the terminal must be reset to enable the settings.
ii Automatic switching
Up to 3 SSIDs can be registered in one configuration (INI) file, and the terminal automatic switches
to the best SSID to suit the access point search conditions.
Purpose of use
In this case, there are multiple access points with different SSIDs on the same site, and the one
to connect to is switched automatically due to movement.
Comparison
Method Connection speed Casio expanded/
TCPIP settings
Switching
[1] Manual
switching
High A different
configuration can be
set up for each SSID.
This is manual, and a reset
is required for switching.
[2] Automatic
switching
In some cases, this
process may take some
time, due to the
searched SSIDs and
the defined order of
SSIDs.
The same settings
must be made for all
SSIDs.
The process is automatic
and no reset is required.

Casio DT-X200 Series Specifications

General

Brand	Casio
Model	DT-X200 Series
Category	Handhelds
Language	English