E-20
Attaching the Hand Strap
The hand strap can be used to prevent the Handheld Terminal from fall. Since there
are four strap holes where the hand strap can be attached, use the hole that affords the
greatest ease of use. Attach the hand strap according to the procedure described below.
To attach the hand strap
1. Pass the thin cord of the hand strap through the strap hole on the back of the
Handheld Terminal.
2. Pass the other end of the strap (the part you put around your wrist) through the loop
formed by the thin cord.
Important!
Do not swing the Handheld Terminal around holding the hand strap.
•
To Next Page
Loading...
Need help?
General