E-21
Calibrating Touch Panel Alignment
Whenever the response of the touch panel is poor, or operation being executed does
not match with the location you are tapping on the touch panel, please recalibrate the
alignment of the touch panel using the following method.
Press the “Fn” key and then press the “4” key after confi rming that “F” is displayed
in the lower right corner of the screen. The following screen is displayed.
∗
You can also display this screen by navigating as follows:
Start
Settings
Stylus
Screen
Align Screen
Press the stylus against the center of the target mark (+ mark) as indicated on the
screen.
Press the stylus against the target mark on the screen 5 times to display the next
screen. Then press the Enter key or tap anywhere on the screen.
•
•
To Next Page
Loading...
Need help?
General