Casio DT-X200 Series - Performing a Full Reset (Initialization)

E-35
1. While holding down the Fn key and CLR key, push down the reset switch for about 3
seconds with the pen (stylus) until the message shown below appears on the display.
To cancel the full reset operation, press the L Trigger key.
R Trigger Key
2. Press the R Trigger key. This causes the message shown below to appear.
To cancel the full reset operation, press the L Trigger key.
R Trigger Key
3. Press the R Trigger key again to perform the full reset.
The full reset starts and all data in the memory are erased, and the start-up screen
appears.
Data stored in the Flashdisk folder remain unaffected.
•
•
•