220
Appendix
Folder cannot be
created.
You are trying to record a file while there are already 9999
files stored in the 999th folder. If you want to record more,
delete files you no longer need (page 39).
LENS ERROR
This message appears and the camera turns off whenever
the lens performs some unexpected operation. If the same
message appears after you turn power back on, contact a
CASIO authorized service center or your original retailer.
LENS ERROR 2
The Anti Shake unit of the camera may be malfunctioning.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
Load paper! The printer ran out of paper while printing.
Memory Full
Memory is full with images you recorded and/or files saved
by editing operations. When shooting with Prerecord CS,
this message indicates that there is not enough memory
capacity to record all of the pre-recorded images. Delete
files you no longer need (page 39).
Printing Error
An error occurred while printing.
• The printer is turned off.
• The printer generated an error, etc.
Record Error
Image compression could not be performed for some
reason during image data recording. Perform a zoom
operation to change the composition of the image and
shoot it again.
RETRY POWER ON
The lens came into contact with an obstruction while
moving. The camera will turn off automatically when this
message appears. Remove the obstruction and turn power
back on again.
SYSTEM ERROR
Your camera system is corrupted. Contact your retailer or a
CASIO authorized service center.
The card is locked.
The LOCK switch of the SD, SDHC, or SDXC
memory card loaded in the camera is in the
locked position. You cannot store images to
or delete images from a memory card that is
locked.
There are no files.
There are no files in built-in memory or on the memory
card.
There are no
printing images. Set
up DPOF.
There are currently no files specified for printing. Configure
the required DPOF settings (page 168).
There is no image to
register.
The setup you are trying to save is for an image that cannot
be saved as a user “CUSTOM SHOT” scene.
LOCK
To Next Page
Loading...
Need help?
General
