90
Other Playback Functions (PLAY)
1. Use [8] and [2] to select the editing method you want to use and then
press [SET].
2. Use [4] and [6] to scroll through the movie and
search for the frame (point) from which or to
which you want to cut the movie (the cut point).
• You also can search for the cut location by playing
back the movie and pressing [SET] to pause. During
playback, you can press [4] or [6] to perform fast
reverse or fast forward.
3. When the frame where you want the cut point to
be is displayed, press [2].
4. Use [8] and [2] to select “Yes” and then press [SET].
The selected cut operation will take considerable time to complete. Don’t try to
perform any camera operation until the “Busy... Please wait...” message
disappears from the monitor screen. Note that a cut operation can take a long
time if the movie being edited is long.
IMPORTANT!
• When you edit a movie, only the result is saved. The original movie is not retained.
An editing operation cannot be undone.
Cut
(To-Point Cut)
While the frame you want the cut to be up to is
displayed, press [2].
Cut
(Point-To-Point Cut)
1
While the frame you want the first (From) cut to be is
displayed, press [2].
2
While the frame you want the second (To) cut to be
is displayed, press [2].
Cut
(From-Point Cut)
While the frame you want the cut to be from is
displayed, press [2].
Cut range (red)
To Next Page
Loading...
Need help?
General
