154
Using the Camera with a Computer
IMPORTANT!
• When on an aircraft or in any other location where use of wireless communication
is limited or prohibited, do not use a FlashAir card, or change the camera’s
“FlashAir” setting (page 159) and the FlashAir card’s setting to those shown below.
FlashAir: Off
Memory Card: Start with the control image
• Loading a FlashAir card into the camera will cause the FlashAir icon to appear
on the monitor screen.
• The following applies to camera operations while image data on a FlashAir card is
being manipulated from a smartphone or other device.
– icon displayed on the monitor screen.
– The Sleep function (page 164) and Auto Power Off function (page 164) are
disabled.
– A confirmation message appears on the monitor screen if you try to turn it off. If
this happens, follow the instructions in the message (page 188).
• The FlashAir wireless LAN connection is automatically terminated if no operation is
performed for a certain amount of time.
• Recording or playing back a movie to a FlashAir card can result in breaks in the
image and/or audio.
• Proper FlashAir card communication may not be possible due to camera settings,
battery level, or operating conditions.
• Changing the configuration of camera settings and performing other operations
may take longer than normal when a FlashAir card is running.
Transparent No wireless LAN connection
Not transparent Communication enabled
Flashing Running (Communication disabled)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
