72
Recording Movies
With Prerecord Movie, the camera continually updates a buffer that stores up to five
seconds of movie images. This lets you record a move that contains what happened
five seconds before you started recording, followed by real-time recording. Pressing
[0] (Movie) saves the pre-recorded action (buffer contents) followed by real-time
recording. Real-time recording continues until you stop it. Prerecord Movie can be
used when shooting a standard (STD) movie, a high-definition (FHD) movie, or a high
speed (HS) movie.
• When using Prerecord Movie in combination with high speed movie, the buffer will
store two seconds of pre-recording instead of the usual five.
. To set up the camera to shoot with Prerecord Movie
1. Set the mode dial to [b] (BEST SHOT).
2. In the REC mode, press [MENU].
3. Use [4] and [6] to select the “Quality” tab.
4. Use [8] and [2] to select “» Quality” and then press [6].
5. Use [8] and [2] to select the movie mode you want to use for
shooting.
6. Press [SET].
7. Press [SET].
8. Use [8], [2], [4], and [6] to select the “Prerecord (Movie)” scene and
then press [SET].
This causes ‰ (Prerecord (Movie)) to appear on the monitor screen, indicating
that the camera is prerecording to its buffer.
Using Prerecord Movie (Prerecord (Movie))
[0] (Movie)
Movie
Real-time recording start
5-second prerecorded part (from the buffer)
• Approximately two seconds for high speed movie
[0] (Movie)
Real-time recording end
To Next Page
Loading...
