E-29
Input an initial value for X (Here, input 1): 1 =
= 7 ==
= 13 ==
Statistical Calculations (STAT)
To start a statistical calculation, perform the key operation N3(STAT)
to enter the STAT Mode and then use the screen that appears to select the
type of calculation you want to perform.
To select this type of statistical calculation:
(Regression formula shown in parentheses)
Press this key:
Single-variable (X)
1(1-VAR)
Paired-variable (X, Y), linear regression (
y = A + Bx)
2(A+BX)
Paired-variable (X, Y), quadratic regression
(
y = A + Bx + Cx
2
)
3( _+CX
2
)
Paired-variable (X, Y), logarithmic regression
( y = A + Blnx)
4(ln X)
Paired-variable (X, Y),
e exponential regression
(
y = Ae
B
x
)
5(
e^X)
Paired-variable (X, Y),
ab exponential regression
(
y = AB
x
)
6(A
•B^X)
Paired-variable (X, Y), power regression (
y = Ax
B
)
7(A
•X^B)
Paired-variable (X, Y), inverse regression
(
y = A + B/x)
8(1/X)
Pressing any of the above keys (1 to 8) displays the Stat Editor.
Note: When you want to change the calculation type after entering the STAT
Mode, perform the key operation 11(STAT/DIST)1(Type) to display
the calculation type selection screen.
Inputting Data
Use the Stat Editor to input data. Perform the following key operation to
display the Stat Editor: 11(STAT/DIST)2(Data).
The Stat Editor provides 40 rows for data input when there is an X column
only or when there are X and Y columns, 20 rows when there are X and FREQ
columns, or 26 rows when there are X, Y, and FREQ columns.
Note: Use the FREQ (frequency) column to input the quantity (frequency) of
identical data items. Display of the FREQ column can be turned on (displayed)
or off (not displayed) using the Stat Format setting on the setup menu.
MathMath
MathMath
MathMath
To Next Page
Loading...
Need help?
General
