E-21
Part 9 Memory
This part of the manual tells you how to store text data in memory for instant
recall when you need it. You can store two blocks of text in memory, containing
up of 80 characters.
Important!
• All data stored in memory is deleted whenever batteries go dead and when
you replace batteries. Be sure to keep written backup copies of all important
data.
To store data
1. Input the text you want to store.
2. Press MEMORY.
3. Press z and x to select STORE.
SOER
LAL
T
CE
R
4. Press SET.
5. Use z and x to select the location of the data you want to store.
6. Press SET to store the text in memory or ESC to abort the store procedure
without storing anything.
• If there is nothing in memory yet, pressing SET stores your text.
• If there is already text stored in memory, the message “OVERWRITE? SET/
ESC” appears when you press SET. Press SET again to replace the existing
text with the new text, or ESC to cancel the store operation.
5. Enter the text you want and then press SET.
Here we will input text for three items.
•You also can specify style (bold, outline) settings, if you want.
•You also can select the “Boxed Text” effect.
The following screen appears after input of all the label data is complete.
PINT
T
R
IX
E
6. Use
z and x
to select “PRINT” and then press SET.
This will display a screen for specifying the number of copies.
7. Specify the number of copies and then press SET to start printing.
•You also can select the FORM “Mirror” setting (page E-19) while entering text.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
