Casio PX-150 - SPEAKER REMOVAL PROCEDURE

PX-150
– 21 –
<Caution When Replacing With New Parts>
• A new PCB UNIT/CNA does not come with the SPONGE/35X150. When replacing the PCB
UNIT/CNA, attach the SPONGE/35X150 to the cables.
<Notes on Assembly>
• Before assembling the PCB UNIT/CNA, check that the KNOB/for ROTARY, TACT BUTTON,
LED COVER, LED SPACER, and FABRIC SHEET have been assembled to the CASE/PANEL.
H. Remove the SPEAKER
NOTE: The basic procedure to remove the part is the same on both sides.
H-1. Undo two screws and then remove the SPEAKER.
H-2. Unsolder the harness.
<Left speaker> <Right speaker>
Positive terminal (Red) Negative terminal (White)
SPEAEKER
Negative terminal (Black) Positive terminal (Red)