12
E
Getting Started
REG2 X1
REG1 Z1
OFF X2/Z2
RF
PGM
Loading journal paper
The same type of paper (45 mm × 83 mm) is used for receipts and journal. Load the new paper before
first operating the cash register or when red paper appears from the printer.
Step 1
Use a mode key to set the
mode switch to REG1
position.
Step 2
Open the printer cover.
Step 3
Cut off the leading end of
the paper so it is even.
Step 4
Ensuring the paper is being
fed from the bottom of the
roll, lower the roll into the
space behind the printer.
Step 5
Drop the paper roll gently
and insert paper to the paper
inlet.
Step 6
Press the j key until
about 20 cm to 30 cm of
paper is fed from the printer.
Step 7
Slide the leading end of the
paper into the groove on the
spindle of the take-up reel
and wind it onto the reel two
or three turns.
To Next Page
Loading...
