Basic Operations and Setups
32
E
Assigning a clerk
You can assign clerks by using clerk button or by clerk secret number. (Clerk buttons
are not equipped.)
Clerk number key
Clerk sign on
OPERATION RECEIPT
Signing clerk 1 on:
1 6 o
Signing clerk 2 on: 2 6 o
○○○
Signing clerk 15 on: 15 6 o
• If you do not want the clerk number to be shown on the display, press o before entering the number.
Clerk sign off
OPERATION
Signing clerk off:
0 6 o
(except PGM mode)
• The current clerk is also signed off whenever you set the mode switch to OFF position.
Important!
• The error code “E008” appears on the display whenever you try to perform a registration, a read/
reset operation without signing on.
• A clerk cannot sign on unless other clerk is signed off.
• The signed on clerk is also identified on the receipt/journal.
Clerk secret number
(1 ~ 15 is set as default.)
Mode switch
ALL
— Clerk name/machine No./consecutive No.
* COMMERCIAL MESSAGE *
REG 03-06-2007 11:58
C01 MC#01 000123
1 DEPT01 T1 $1.00
To Next Page
Loading...
Need help?
General
