14
E
Getting Started
Plug the cash register into a wall outlet.
Be sure to check the sticker (rating plate) on the side
of the cash register to make sure that its voltage
matches that of the power supply in your area.
Insert the mode key marked “PGM” into the mode switch.
Turn the mode key to the “REG” position.
The display should change to the following.
REG2
REG1
OFF
RF
PGM
X1
Z1
X2/Z2
REG2
REG1
OFF
RF
PGM
X1
Z1
X2/Z2
4.
5.
6.
After this step, clerk sign-on is necessary (refer to page 32).
To Next Page
Loading...
