Casio XW-P1 User Guide

Sounding Arpeggio Phrases Automatically
E-43
Use the procedure below to clear preset step data or step
data that was edited using Step Edit (page E-42) and create
new step data from scratch.
• Note that variation type data cannot be cleared.
1. Hold down
bm
ARPEGGIO until the type
selection screen shown below appears on the
display.
2. From among the preset or user arpeggio types
select the arpeggio type you want to clear.
• The procedure for selecting an arpeggio type is the
same as that for selecting a tone (page E-20).
3. Press
7
EDIT.
4. Use the
bq
up (q) and down (w) buttons to
move the item selection cursor (0) to “Clear
Step”, and then press
bq
ENTER.
5. Press
bq
ENTER again.
This should cause “Clear?” to appear on the display.
6. Press
bq
YES.
The message “Complete!” will appear on the display when
the data is cleared.
Clearing Arpeggio Data

Casio XW-P1 Specifications

General

Polyphony	64 notes
Arpeggiator	Yes, 6 types
Power Supply	D batteries x 6, AC Adapter
Dimensions	95.7 x 39.7 x 11.1 cm
Weight	13.2 lbs
Effects	Reverb, Chorus, Delay, Distortion, Rotary Speaker
Display	LCD
User Tones	100
Inputs/Outputs	USB
User memory	100 user tones
Controllers	Pitch Bend Wheel, Modulation Wheel
Inputs	Line In
Outputs	1/4" L/Mono, R output
Keyboard	61 keys
Connections	USB