Cassese CS 940 - Cut of the First Piece

USER & PARTS MANUAL
CS940
28
5.B.f Cut of the first piece
20
9
16
9
17
9
18
9
19
9
Make sure the blades are
rotating or press the button
(18) of the control panel to
switch on your blades.
Make sure the moulding is
against the measurement
stop.
Example of bad
positionning of the
moulding, the left clamp
will push the moulding
against the right blade
during the cut, causing
damage to the blade and
the moulding.
Figure 5-17
Figure 5-18
Release the pedal and
make sure the moulding is
hold firmly in place by the
clamps.
First, press the button (20)
and keep it pressed, then
pull down the right handle
to do the cut.
Figure 5-19
Adapt the mouvement to the type of material to be cut. Plastic must be cut in a fast motion whereas hard wood and
thick mouldings will require a slower movement. It is also advised to help the blades back movement, do not release
suddenly the handle which would result in a shock and vibrations which are not good for the quality of the cut and
the durability of the system. Keep the button (20) pressed during the complete cycle of the machine.
For your safety, releasing the button (20) while the right blade is not back up will stop the blade rotation.Press the
button (18) to restart the blades if needed.
If after a cut a piece of wood needs to be pushed out of the machine and is not accessible, do never introduce your
hands bellow the brushes. Push that piece using another piece of wood.