6.D EMPTY THE WASTE BOX
6.E PERIODICAL MAINTENANCE
Before performing any maintenance , switch off the main electrical contactor (12) and the air rotating switch (15)
and lock it with a locker.
It is recommended to perform that quick maintenance daily :
- Clean the inside of the machine, make sure there is no wastage jammed inside it or under the cutting heads.
- Clean the front plexiglass for a better vision, do not use solvant to clean it !
- Clean the wastage box before it is full.
- Make sure the extremities of the horizontal and vertical clamps are in correct shape, contact your local dealer if some
parts are needed.
Before performing any maintenance , switch off the main electrical contactor (12) and the air rotating switch (15)
and lock it with a locker.
Your machine is equiped
with a waste box
(reference Z27210). Its
access is protected by a
front door.
Pull on the handle of the
door to open it.
Pull the box out of the
machine and clean it.
Put back the box inside
the machine.
It is strictly forbidden to use the machine without the waste box as the extraction will not perform well without
that box inside the machine. It is recommended to use a waste box of exactly the same sizing to avoid leackage
that would result in poor dust collection. You can order the genuine waste box under the reference: Z27210.
A safety sensor (G)
prevents from starting the
machine when the
wastage compartment is
opened.
To Next Page
Loading...