Low setting
THIS APPLIANCE IS INTENDED FOR DECORATIVE PURPOSES.
P
lease also familiarise yourself with the
N
otes for the Installer and End User
o
n page 4.
O
PERATION AND CONTROLS
It is most important that the operator of this gas appliance has fully read and understood all the operating,
c
leaning and maintenance procedures as laid out in these instructions.
USER INSTRUCTIONS
15
P
ush these two buttons
together to light the fire
Remote handset
High setting
S
ensor
Ensure the bulbous side of the
sensor is towards the front.
Lighting Procedure
The remote control handset generates an infrared signal that will be received by the sensor situated at the front
of the fire. the infrared signal requires a direct line of sight from the handset to the sensor on the appliance to
ensure good operation.
To light the fire, point the handset at the sensor at the front of the fire. Push and hold the two buttons on the left
hand side of the handset together. The appliance will make a beep sound and you can release the buttons. After
a few seconds you will hear the clicking spark to the pilot light. Once the pilot is lit the fire’s main burner will
come on to the high position. This whole process should take no longer than than 20 seconds.
After 30 minutes you can turn the fire down, point the handset at the sensor on the appliance then push and hold
the minus button (small flame), if you release immediately the flame will go to low. If you hold the button down,
the flame will lower slowly and you can release the button to your desired position.
T
o turn the fire up, point the
handset at the sensor and push the plus button until the desired flame height is reached.
The fire may be left in standby mode (pilot only) by pressing the small round button on the handset. To turn the
fire of
f, point the handset at the sensor and push the top left button, the fire will go out.
NOTE: When the battery power is becoming low
, the beeping sound will continue every time you use
the fire. Please replace with good quality
Alkaline or Lithium 6 x 1.5V
AA.
NOTE: If for any reason the gas supply is interrupted whilst the fire is in use, it will be necessary to
reset the fire controls by pressing the top left button on the handset.
WARNINGS:
Never throw any type of rubbish on or otherwise disturb the fuel bed.
Any alteration to this appliance including its ceramic components may render it inoperable and
unsafe.
AL
W
A
YS run this appliance on the high setting for the first 30 minutes (minimum) - Failure to do this
may result in poor combustion and excessive sooting.
Fig. 12
To Next Page
Loading...