Cast Tec recommend that this appliance is serviced at regular 12 monthly intervals. The chimney or flue
should also be checked regularly to ensure that all products of combustion are entering the flue and
t
here is no excessive build up of soot.
I
t is the users responsibility to ensure that the appliance is kept in a clean serviceable condition.
1. Ceramic Components and Fuel Bed - Debris from any
source should be removed with a soft brush. Please ensure
t
hat any debris including soot deposits are removed from the
appliance and not left on the fuel bed. It is recommended
that the user should, on a regular quarterly basis, carefully
remove all ceramic components and thoroughly clean the
stainless steel burner strip and the pilot assembly. Any build
u
p of debris in this area could affect the operation of the
appliance.
NOTE: It is common to find surface cracks in the ceramic components. This is due to the expansion and
contraction of the ceramic fibres caused by the intense heat that the burner generates. The cracks will not
affect the safe operation of this appliance. However great care must be taken when handling the ceramic
components as they will break if handled incorrectly. Do not use a vacuum cleaner to clean the ceramics.
2.
Radiant Box Ceramic Liners - Use only a soft brush to remove any soot deposits from the ceramic liners
during cleaning as this is the only method that can be used to remove deposits. The ceramic liners are very
delicate and should be treated accordingly.
3.
Brass Trims and Frets - The brass trim and fret should be removed from the appliance for cleaning, please
ensure that the appliance has cooled thoroughly. Polished metal trims and frets are not lacquer coated and
therefore require polishing. It is recommended that a good quality metal polish is used.
4.
Changing the batteries - When the batteries are becoming discharged, the fire will emit a continuous
beeping sound. The battery pack is held in place with a single screw, remove this screw and the pack can slide
out. Unclip the cover and replace the batteries with good quality alkaline or lithium - 6 x 1.5V AA (Fig. 14).
CLEANING AND MAINTENANCE
16
S
tainless Steel
Burner Strip
P
ilot Assembly
F
ig. 13
Fig. 14
Battery Pack
Retaining screw
To Next Page
Loading...