OWNER’S MANUAL PAGE 35
Adjust the neck rest
Remove the screws from the clamps to mount on the top
horizontal seat bar. Place shims in clamps and center the
space neck rest. Snug up the clamp bolts. You’ll likely be
moving these clamps as you adjust the neck rest.
You can now adjust the space neck rest height and angle to fit
rider. The neck rest is a standard feature on the 700 and
Expedition. It is an optional feature on other models. Loosen
quick release to adjust height. Loosen the top adjusting bolts
to adjust the angle of the top of the space neck rest. Position
the neck rest where you want it. Tighten all the bolts and you
are ready to ride in style!
It is normal for cables and assembled parts to settle and “bed in”
during the first several days of riding. It is important to go over
the trike carefully during this break-in period and adjust anything that’s loosened up.
That means all fasteners, especially the axle quick releases and the tie rod nuts and
bolts.
To Next Page
Loading...
