8
Rear Panel
1. Signal Input Terminal
Used for audio source input.
2.Tubes Selection Switch
Used to select tube EL34 or KT88.
3. Right Channel Output
Used to connect with the right channel of speaker.
4. Left Channel Output
Used to connect with the left channel of speaker.
5. Power Socket with Main Fuse
Main fuse is located just below the power socket.
Replace the fuse with the same type as indicated.
Power tube replacing:
1. Refer to the "Tube Replacement" on page 11, find
out what types of tubes you can use for replacement.
2. Tube Sel. on the rear panel must be turned to
position KT88,if you are going to use KT88 series
of tubes for replacement.
3. Tube Sel. on the rear panel must be turned to
position EL34,if you are going to use EL34 series of
tubes for replacement.Bias adjustment methods
please refer to page 9.
CS-88A
ZHUHAI SPARK ELECTRONIC EQUIPMENT CO., LTD.
T3.15AL250V
TUBE SEL.
EL34
KT88
PRE IN
PHONO
LINE1 LINE2
5
1
2
3
4
2