EasyManua.ls Logo

CBE PC380-BS - Electrical System Functions Explained

CBE PC380-BS
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
EN
IMPORTANT in the case of installation of equipment that needs permanent exclusion of the battery parallel
relay (ref. 1), you must remove the R resistor (ref. 2). The resistor can be removed using a wire cutter,
being careful not to damage the PCB traces below.
:
72
This resistor is 520
Juny 2020.
present on all DS distribution boxes
manufactured since
ELECTRICAL SYSTEM FUNCTIONS
b) by 230V net: buffer system through battery
c) by solar panel: through solar regulator.
An electronic device controlled by the “+ key” ON
switches on the D+ functions (batteries parallel, OUT
D+ simulated output, awning light etc.) when the car
battery voltage is > 13.5V and switches them off with
the “+ key” OFF or with voltage < 12.5V.
D+ FUNCTIONS
The D+ functions can be activated only if the B2
leisure battery is connected.
charger.
a) by alternator: through the separating relais,
s when the engine i started.
Operation without SMART ALTERNATOR:
CAR BATTERY (B1) RECHARGING
When the battery charger is charging, an electronic
device allows a recharging ( A) of
the car battery (B1), the system gives priority to the
leisure battery (B2).
nominal current 2
LEISURE BATTERY (B2) RECHARGING
Condition A: with “+ key” ON signal and car battery
voltage > 13,5V. The functions are
deactivated with “+ key” OFF or with
voltage < 12,5V.
Condition B: with “+ key” ON signal and “D+”
negative signal (-). The functions are
deactivated in absence of one of
those two signals.
Operation with SMART ALTERNATOR (present on
all DS distribution boxes manufactured since
September 2019)
520
:
The D+ functions can be activated only if the B2
leisure battery is connected.
For vehicles equipped with SMART ALTERNATOR
n electronic device switches on the D+ functions
(batteries parallel, OUT D+ simulated output, awning
light etc.) when the engine is running. The D+
functions are activated in presence of at least one of
following conditions:
,
a
N.B.: In presence of both conditions, the functions
are deactivated in absence of the “+ key” signal.
1
2

Related product manuals