CC-ISOBUS CCI 50 - 3 Set-Up for Operation; Connecting the Terminal

CCI.ControlCCI.Control – Set-up for operation
8
Pos: 5 /CC-Isobus/A ufbau @ 8\m od_12735851 12215_6.doc @ 120207 @ 1 2223333333332
Pos: 7 /CC-Isobus/I nstallation @ 8\mod_1273 570481145_6.d oc @ 120033 @ 1223333
3 Set-up for operation
3.1 Connecting the Terminal
3.1.1 Connecting with a GPS receiver
The use of a GPS receiver is required in order to process a section-specific task.
For information, please refer to the chapter Connecting with a GPS receiver in
the CCI.GPS operating instructions.
3.1.1.1 GPS data requirements
The following NMEA message packages enable error-free operation with
CCI.Control:
 GGA, VTG, ZDA, GSA
 GGA, RMC, ZDA, GSA
 GGA, VTG, RMC, GSA
 GGA, RMC, GSA
 RMC, GSA