12
Possible problems and remedies
The supply line is attributed with the cause of the most
common difficulties. In the case of breakdown, proceed as
follows:
1) Check the value of the supply voltage
2) Check that the power cable is perfectly connected to the
plug and the supply switch
3) Check that the power fuses are not burned out or loose
4) Check whether the following are defective:
• the switch that supplies the machine
• the plug socket in the wall
• the generator switch.
NOTE: given the required technical skills necessary for the
repair of the generator, in case of breakdown we advise you to
contact skilled personnel or our technical service department.
Procedure for welder assembly
and disassembly
Proceed as follows:
• undo the 4 screws securing the cover to the front and rear
panel.
• remove the cover from its seat.
Proceed the other way round to re-assemble the welder.
To Next Page
Loading...
