To Next PageTo Next Page
Need help?Do you have a question about the CEA DIGITECH 400 PULSED and is the answer not in the manual?
Overview of the DIGITECH 400 PULSED welder and TA4 wire-feeder.
Details connecting the wire-feeder to the generator.
Steps for connecting the system for TIG welding.
Setup instructions for MIG-MAG welding.
Procedures for connecting the welder to the main electrical supply.
Step-by-step guide for loading wire into the wire feeder.
Explains the function of each key on the control panel.
Details electrode welding process and parameters.
Setup and procedures for MIG welding modes.
Steps to create, copy, change, and delete automatic welding spots.
Recommended maintenance for the welder, wire-feeder, and torch.
Explains error displays, descriptions, codes, and diagnosis.
Guides on troubleshooting supply line and general operational issues.
Procedures for replacing electronic circuit boards.
Provides clear instructions on how to order spare parts.
General| Welding Process | MIG/MAG, Pulsed MIG |
|---|---|
| Pulsed MIG | Yes |
| Duty Cycle at 400 A | 60% |
| Power Supply | Inverter |
| Pulse Width Adjustment | Yes |
| Wire Feed Speed Range | 1 - 24 m/min |
| Protection Rating | IP23 |
| Input Voltage | 400V |
