CONGA 1090 | 31
ENGLESK
placed in order to prevent product damage and ensure safe operation.
Fig. 19
Direct exposure to sun light or great light contrasts may aect to the cor-
rect operating of the sensors. If this happens and the robot stops, change
it to a new location for it to start operating again.
1. Place the charging base against the wall and leave a minimum free space
of:
2 metres to the front.
1 metre to each side.
Fig. 20
2. Connect the charging base to a power supply. Wind and store the re-
maining cord in the lower part of the charging base to avoid accidents.
Fig. 21
3. Install both side brushes in their corresponding slots, located on the ro-
bot’s bottom part. Press until it clicks to make sure they are properly xed.
Fig. 22
4. Press the power switch located on the bottom part of the robot. Make
sure the power switch is turned On.
Fig. 23
5. Place the robot on the charging base and make sure the charging termi-
nals on the robot match with those of the charging base. Once the robot is
properly placed, it will beep once and the power button will light up If the
light blinks orange, it means the battery is not completely charged. To en-
sure maximum cleaning time, wait until the light switches to steady blue.
This will indicate the battery is fully charged and that the robot is ready to
clean.
Fig. 24
4. Operation
Start cleaning
Long press the power button on the robot to activate the robot up.
Press the power button on the robot or on the remote control to start
cleaning.
Note: If the robot runs out of battery during cleaning, it will automatically
To Next Page
Loading...
