CONGA 1090 | 35
ENGLESK
Conguration with the remote control
Press the schedule button on the remote control. Digits will start blinking.
Fig. 36
Use direction buttons to select the day. Once selected, use right and left
buttons to select minutes and hours. Use direction buttons when digits are
blinking to congure the desired minutes and hours. Press the power but-
ton to save settings. Enter the desired days and follow the same steps to
schedule them.
Fig. 37
Finally, press schedule button to exit scheduling mode. The robot will beep
once indicating the scheduled cleaning settings have been conrmed.
The user may schedule as many days per week as desired. The home screen
will display when the robot is scheduled.
Cancelling scheduled cleaning
Press the schedule button on the remote control, select the day you wish
to delete and change the set time to 00:00 am., this is the time to be set to
cancel the cleaning program.
Fig. 38.
5. Cleaning and maintenance
In order to lengthen your robot’s shelf life and to allow your robot to oper-
ate at peak performance, carry out the following procedures periodically.
Empty the robot’s dust tank.
Press the dust tank’s release button.
Fig. 39
Open the dust tank and empty it.
Fig. 40
Clean the robot’s lter.
Remove the lter.
Carefully shake o all dust from the lter.
Fig. 41
Clean the free-fall sensors
Use a clean, dry and soft cloth to wipe o any dust from the free-fall sen-
sor located on the right side of the robot’s bottom part.
Warning: Do not spray cleaning products directly on the sensor.
Fig. 42
To Next Page
Loading...
