cecotec Conga 1090 Connected - Charging Base Placement; Connecting Power Supply; Side Brush Installation; Power Switch Activation

32 | CONGA 1090
ENGELSK
return to the charging base. Once the battery is fully charged, the robot can
start a new cleaning cycle.
Warning: If there is no good access to the charging base, the robot will not
be able to return to its charging position. In that case, once the robot has
stopped, take it manually to the charging base.
Pause
Press the power button on the robot or on the remote control to pause the
cleaning process.
Press the power button on the robot or on the remote control to resume
the cleaning process.
Fig. 25
Return to the charging base
Press the back home button on the robot or on the remote control in order
to send the robot to the charging base.
Turn o
Long press the power button to turn the robot o.
Fig. 26
Warning: The robot vacuum cleaner has a power switch located on its main
body. If the robot is not going to be used for long periods of time, it is sug-
gested to switch it o. If the robot is switched o, it will restore factory de-
fault settings as a safety measure. The robot will only carry out scheduled
cleaning if it has been scheduled while the switch is ON, otherwise, it will
have to be scheduled again from the remote control or the App.
Cleaning modes
This robot includes dierent modes and dierent functions that can be ac-
tivated from the remote control or the App.
The App is only compatible with Conga 1090 Connected, Conga 1090 Con-
nected Force and Conga 1099 Connected.
Auto mode
Press the power button for the robot to start Auto cleaning mode.
The robot will clean the whole surface, edges, around objects such as ta-
bles, chairs etc. Once it starts running out of battery, it will return to the
charging base.
Fig. 27