38 | CONGA 1090
ENGELSK
6. Troubleshooting
Robot signal Cause Solution
Red light
steady on
1 beep
Omnidirectional
wheel error
Clean the omnidirectional
wheel and press the power
button to restart.
2 beeps
Robot’s side
brush error
Clean the side brushes and
press the power button to
restart the robot.
3 beeps
Motor fan or
lter error
Remove and empty the dust
tank.
Remove the robot’s lter and
shake o any dust rests.
4 beeps
Main brush
error.
Remove and clean the
robot’s dust tank.
Red light
blinks
2 beeps Bumper error
Check if the bumper is
blocked and press on both
sides and center to unblock
it.
3 beeps
Free-fall sensor
error
Check if the robot is placed
on an uneven surface, if its
wheels are o the ground
or if it is stuck in a dark
place and move it to a new
location. If not, clean the
free-fall sensor.
Red light
steady on
4 beeps
The robot
cannot return
to its charging
base or starting
position
Make sure there are no
obstacles in front of the
charging base. Clean the
charging terminals on both
the charging base and the
robot with a clean, soft and
dry cloth.
To Next Page
Loading...
