Fig. 34
Remove any hair, fluffs or dust collected in the brush and around the axes.
Fig. 35
Clear and clean the robot’s suction channel.
Fig. 36
Reinstall the main brush and its frame.
Fig. 37
High-efficiency filter
The high-efficiency filter is designed with fibres that help trapping dust particles, dust mites, pollen… It is very
important to clean periodically the filter, to avoid these particles from building up in the filter, causing efficiency loss. It
is convenient to carry out this maintenance once a week.
It is suggested to replace the filter by a new one after a maximum of 160 hours of use. Recommendations: Dirt can
be removed with a small brush or by shaking it carefully against a hard surface for dust to fall off. The high-efficiency
filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a mesh primary filter and a sponge filter. It is suggested to replace them either
after a maximum of 160 hours of use or when they are worn out due to operation.
Recommendations: Dirt can be removed with a small brush or by shaking it carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always make sure they are
completely dry before installing them again.
Side brushes
To Next Page
Loading...
