1. Charge indicator
2. Signal transmitter
3. Charging terminals
2. BEFORE USE
Take the product out of the box.
Remove all packaging material Save the original box.
Make sure all parts and components are included and in good conditions. If any visible signs of damage are
observed, contact the Technical Support Service immediately.
Note: Remove all objects around the robot such as clothing, papers, cables, curtains or other fragile objects.
Fig. 15
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to prevent product
damage and ensure safe operation.
Fig. 16
Direct exposure to sun light or great light contrasts may affect to the correct operating of the sensors. If this happens
and the robot stops, change it to a new location for it to start operating again.
Place the charging base against the wall and leave a minimum free space of:
2 metres to the front.
1 metre to each side.
Fig. 17
Connect the charging base to a power supply. Wind and store the remaining cord in the lower part of the charging
base to avoid accidents.
To Next Page
Loading...
