through the App.
4. CLEANING AND MAINTENANCE
In order to lengthen your robot’s shelf life and to allow your robot to operate at peak performance, carry out the
following procedures periodically.
Empty the robot’s dust tank.
Press the dust tank’s release button.
Fig. 30
Open the dust tank and empty it.
Fig. 31
Cleaning of the robot’s filter
Remove the filter.
Carefully shake off all dust from the filter.
Fig. 32
Cleaning of the free-fall sensors
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the right side of the robot’s
bottom part.
Warning: Do not spray cleaning products directly on the sensor.
Fig. 33
Cleaning of the main brush
Slightly press the main brush frame’s tabs in order to open the main brush storage gap and to remove it.
To Next Page
Loading...
