CONGA 6090 | 33
ENGLESK
3. Automatic charge/Back home
4. Autoclean/pause
5. Direction buttons
6. Spiral cleaning
7. Room cleaning
8. Scrubbing levels
9. Scheduling
10. Edge cleaning
11. Power levels
2. BEFORE USE
- Take the product out of the box.
- Remove all packing material and keep the original box.
- Make sure all parts and components are included and in good conditions.
If any sign of visible damage is observed, contact immediately with the
ocial Technical Support Service of Cecotec.
Note
Remove all objects around the robot such as clothing, papers, cables,
curtains or other fragile objects. Fig. 18
- If the area to be cleaned has a balcony or stairs, a physical barrier must be
placed in order to prevent product damage and ensure safe operation. Fig.
19
- Direct exposure to sunlight or great light contrasts may aect to the
correct operating of the sensors. When exposed, the robot will stop.
Replace it to start working again.
- Place the charging base against the wall and leave a minimum free space
of:
2 metres to the front.
1 metre to each side. Fig. 20
- Connect the charging base to a power supply. Wind and store the
remaining cord in the lower part of the charging base to avoid accidents.
Fig. 21
- Install both side brushes in their corresponding slots, located on the
robot’s bottom part. Press until it clicks to make sure they are properly
xed. Fig. 22
- Press the power switch located on the bottom part of the robot. Make
sure the side power switch is set to the OFF position. Fig. 23
- Place the robot on the charging base and make sure the charging terminals
on the robot match with those of the charging base. Once the robot is
To Next Page
Loading...
