34 | CONGA 6090
ENGELSK
properly placed, it will beep once and the power button will light up If the
light ashes orange, it means the battery is not completely charged. To
ensure the longest cleaning time, wait until the light is steady blue. This
will indicate the battery is fully charged and the robot is ready to be used.
Fig. 24
3. OPERATION
Start cleaning
- Hold down the power button on the robot to turn the robot on.
- Press the power button on the robot or on the remote control to start
cleaning.
Note
If the robot runs out of battery during cleaning, it will automatically return
to the charging base. Once the battery is fully charged, the robot can start
a new cleaning cycle.
Warning
If there is no good access to the charging base, the robot will not be able to
return to its charging position. In that case, once the robot has stopped, take
it manually to the charging base.
Pause
- Press the power button on the robot or on the remote control to pause the
cleaning process.
- Press the power button on the robot or on the remote control to resume
the cleaning process. Fig. 25
Return to the charging base
Press the back home button on the robot or on the remote control in order
to send the robot to the charging base.
Turn o
Hold down the power button to turn the robot o. Fig. 26
Warning
The robot vacuum cleaner has a power switch located on its main body. If
the robot is not going to be used for long periods of time, it is suggested
to switch it o. If the robot is switched o, it will restore factory default
settings as a safety measure. To use the time setting function, the switch
To Next Page
Loading...
