cecotec CONGA 2290 - Cleaning and Maintenance; Dust Tank and Filter Cleaning; Sensor and Main Brush Maintenance; High-Efficiency Filter Care

38 | CONGA 6090
ENGELSK
4. CLEANING AND MAINTENANCE
- In order to lengthen your robot’s shelf life and to allow your robot
to operate at peak performance, carry out the following procedures
periodically.
- Empty the robot’s dust tank.
- Press the dust tank’s release button. Fig. 39
- Open the dust tank and empty it. Fig. 40
Robot lter cleaning
- Remove the lter.
- Carefully shake o all dust from the lter. Fig. 41
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe o any dust from the free-fall sensor
located on the right side of the robot’s bottom part.
Warning
Do not spray cleaning products directly on the sensor. Fig. 42
Main brush cleaning
- Slightly press the main brush frame’s tabs in order to open the main brush
storage compartment and to remove it. Fig. 43
- Remove any hair, us or dust collected in the brush and around the axes.
Fig. 44
- Clear and clean the robot’s suction channel. Fig. 45
- Reinstall the main brush and its frame. Fig. 46
High-eciency lter
- The high-eciency lter is designed with bres that help trapping dust
particles, dust mites, pollen... It is very important to clean periodically
the lter, to avoid these particles from building up in the lter, causing
eciency loss. It is convenient to carry out this maintenance once a week.
- It is recommended to replace the lter with a new one without exceeding
160 cleaning hours.
Recommendation
Dust can be removed with a small brush or by shaking it carefully against a
hard surface for dust to fall o. The high-eciency lter cannot be washed.
Mesh primary lter and sponge lter
The ltering system is featured with a mesh primary lter and a sponge