CONGA 6090 | 41
ENGLESK
Andre mulige scenarier
Problem Solution
The robot does not turn
on
Make sure that the switch is set to the On position.
Make sure the battery is fully charged.
Change the remote control batteries (2 AAA).
Make sure the remote control is within the robot range (16 ft/5
m).
If the problem continues, turn the switch o and restart it.
The remote control does
not work.
Change the remote control batteries (2 AAA).
Make sure the robot is on and the battery is fully charged.
The device suddenly
stops working.
Check if the robot is trapped or stuck with any obstacle.
Check the battery level.
If the problem continues, turn the switch o, wait for 2
seconds and restart it.
The programming
function does not work
Make sure the power switch in the lower part of the robot is on.
Make sure the time (AM/PM) and time settings are correctly
set.
Check if the robot’s battery is too low to turn on.
Suction power level is
very low
Check if there are obstructions blocking the air inlet.
Empty the dust tank.
Clean the lters with a vacuum cleaner or a cleaning brush.
Check if the lters are wet.
Dry the lters in a natural way before using them.
The robot does not
charge.
Check if the charging base indicators are on. If they are not,
contact the ocial Technical Support Service of Cecotec.
Clean the charging terminals with a dry cloth.
Check if the robot beeps when it gets to the charging base.
Otherwise, contact the ocial Technical Support Service of
Cecotec.
The robot does not
return to the charging
base
Remove the objects 1 metre on the left and right, and 2
metres in front of the charging base.
The robot will return to the charging base faster when it
is near it. When it is far, it will take more time to identify it.
Clean the charging terminals.
The main brush does not
spin.
Clean the main brush.
Check if the main brush is installed correctly.
The robot movements
and route are unusual.
Carefully clean the sensors with a dry cloth.
Restart the robot. To do so, turn it o and on.
To Next Page
Loading...
