Why is my cecotec CONGA 990 remote control not working?
If your Cecotec Vacuum Cleaner's remote control isn't working, first replace the batteries with new ones. If that doesn't work, ensure the robot is turned on and fully charged. Also, clean the infrared transmitter on the remote and the reception sensor on the robot with a soft cloth. Finally, avoid using the remote near equipment that produces infrared signals.
What to do if my cecotec CONGA 990 returns to base too soon?
If your Cecotec Vacuum Cleaner returns to the charging base before finishing cleaning, it's likely because its battery is low. To resolve this, allow the robot to charge fully.
General| App Control | Yes |
|---|---|
| Obstacle Detection | Yes |
| Cliff Sensors | Yes |
| Connectivity | Wi-Fi |
| Auto Recharge | Yes |
| Scheduling | Yes |
| Wet Mopping | Yes |
| Cleaning Modes | Auto, Edge, Manual |
| Filter Type | HEPA |
| Voice Control | Yes (Alexa, Google Assistant) |
| Programmable | Yes |
| Virtual Walls | Magnetic strip (not included) |
| Charging Time | 4 hours |
| Dimensions | 350 x 350 x 95 mm |
Details the components of the robot's main body, including sensors, buttons, and wheels.
Provides essential warnings and guidelines before operating the robot for the first time.
Guides through installing side brushes, powering on, and the initial charging process.
Instructions on how to start, pause, and stop the robot using the remote control.
Instructions on how to clean the dust tank and its filters.
Lists common errors indicated by a blinking red light and their solutions.
Lists common errors indicated by a steady red light and their solutions.
Resolves issues such as robot not operating correctly or returning to base prematurely.
To Next Page