Cedima CF-2116 D - Uniform Statement of Conformity

ENGLISH
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
EC Declaration of conformity
Manufacturer:
CEDIMA
®
Diamantwerkzeug- und Maschinenbaugesellschaft mbH
Lärchenweg 3, D-29227 Celle
Compilation, storage of the technical data:
Technical documentation of the
CEDIMA
®
Diamantwerkzeug- und Maschinenbaugesellschaft mbH,
Siedemeierkamp 5, D-29227 Celle
Description of the machine:
Joint cutter CF•2116 D, article no. 30000051 (standard), 30000178 (green concrete)
Self-driving, hand-guided, in green concrete (FB) or standard design. Hydrostatic feed
drive. For wet cutting in asphalt and concrete as well as similar abrasive construction
materials with diamond saw blades up to 800 mm (standard) or 400 mm (FB = green
concrete) diameter with a max. saw blade clamping width of 20 mm. Cutting shaft drive via
V-belts by a 314,7 kW diesel engine. Max. cutting depth 300 mm (standard) or 100 mm
(FB) stepless adjustable via electro-hydraulic frame jack. Water supply via pressure water
connection or of a 35 l tank carried with the machine.
Measured sound power level: L
WA
= 110 dB (A)
Guaranteed sound power level: L
WA(d)
= 114 dB (A)
Method of evaluating the declaration of conformity: RL 2000 /14/EC, appendix V
Herewith we declare that based on the guideline 2006 / 42 / EC, Annex II 1.A dated
2006.05.17 (modications inclusive) of the European Parliament and Council
the joint cutter CF•2116 D beginning with year of construction 2006
complies with the following standards and guidelines:
EN ISO 12100-1, EN ISO 12100-2, EN 13862, EN ISO 14121-1, EN 60204-1, 2000/14/EC
In regard to dangers due to electricity, according to Annex I No. 1.5.1 of the Machinery
Directive 2006/42/EC, the protective aims of the Low Voltage Directive 2006/95/EC
(formerly 73/23/EEC) are met.
In regard to dangers due to radiation, according to Annex I No. 1.5.10 of the Machinery
Directive 2006/42/EC, the protective aims of the EMC Directive 2004/108/EC (formerly
89/336/EEC) are met.
This declaration of conformity immediately becomes invalid if changes are
incorporated to the machine which have not been approved by us!
Celle, 31. 08. 2010
B. Siemsen (managing director)