ENGLISH
37
Maintenance and care
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
When doing care and maintenance work, the general
safety information of this operating manual (chapter
3) must be observed, as well as the engine operating
manual and, if necessary, the operating manual of the
suction system!
DANGER!
Risk of injury! The joint cutter must be
switched OFF when maintenance, care-
and repair work is in process! The machine must
also be blocked against an unexpected rolling
away! An unintentional switch-on must be avoided!
Select a possibly dust free and an
appropriately equipped place to work when
cleaning, maintaining and repairing are to be
carried out!
• Place the joint cutter on a horizontal and even
ground, so that there is enough room for cleaning,
maintenance, care- and repair work all around the
CF-2116 D!
• Clean the joint cutter before each maintenance or
repair work!
• Carry out maintenance work as described in sect. 6.6
according to the recommended cycles (as in table
6.5 on maintenance intervals)! At the same time, all
wearing parts should also be checked and, if neces-
sary, be exchanged and/or adjusted! This also goes
for parts which are not listed in the table!
Keep to the maintenance and inspection
intervals and, let the work be carried out
by a qualied work shop or by CEDIMA®, so
lengthening the working life of the CF-2116 D!
6.1 Cleaning
6.1.1 Cleaning agents
ATTENTION!
Do not use aggressive cleaning agents!
Aggressive cleaning uids, as well as
cleaning with uids which need a temperature of over
30°, are not allowed!
ATTENTION!
Do not use high-pressure steam cleaners!
For safety and functional reasons, steam,
water and cleaning uids must neither penetrate into
engine, air lter, electrical components (electric motor,
switches, plugs and the electronics) nor into roller
bearings!
6.1.2 Information concerning dry cleaning
• Remove dust and dirt with a damp cloth!
• Only use lint-free cleaning material
• Remove stubborn, crusty sediment, when necessary,
with a not too hard brush!
• Blow the protection grids and the cooling ribs through
with compressed air to ensure a disturbance-free
circulation of the cooling air!
6.1.3 Information concerning wet cleaning
• Make sure that, before any cleaning with water or
other uids, the electric sockets are sealed off with
the appropriate covers, to prevent the uids entering!
Cover or mask with a suitable insulation tape, all ex-
posed openings, housings and connecter terminals!
• At the most, remove dirt and sediment with a soft jet
of water and, if necessary, a soft brush!
• Be especially careful concerning critical elements
(e.g. switches, engine, air lter)!
The electrical components may not be cleaned with a
water jet!
• To avoid the danger of the bearings running dry, do
not rinse them! Some of the bearings are lubricated
for life!
• After cleaning, remove all coverings and tapes com-
pletely!
6.0 Maintenance and care of the CF-2116 D
To Next Page
Loading...
