Cedima CF-2116 D - Carry Out Regular Visual Controls; Re-greasing and Corrosion Protection; Maintenance and Care of the CF-2116 D Engine

ENGLISH
38
Maintenance and care
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
6.2 Carry out regular visual controls
ATTENTION!
Make sure the warning- and safety signs
are kept clean and readable, even after a
lengthy period of time!
• Leakage of operating materials and lubricants
Shut down the joint cutter as soon as any leakage is
noticed of diesel fuel, motor oil or hydraulic oil out of
the lifting hydraulics, the hydrostatic feed gearing or
out of the mechanical feed gear as long as the leak-
age is not the result of over-lling.
• Leakage of cooling/rinsing water
Shut down the joint cutter as soon as any leakage of
cooling/rinsing water is noticed (in unusual places)
which is not caused by over-lling! Exchange any
water pipes, couplings or water taps:
• Damage to operational elements such as indicators,
electric plugs, respectively plugs, couplings, hydraulic
couplings and /or of the electric motor with hydraulic
oil pump, electronics (if tted), of the mechanical
system!
ATTENTION!
As soon as any of the above named
defects is detected, shut down the joint
cutter immediately!
Have the joint cutter repaired at a qualied work-shop
or at CEDIMA®!
DANGER!
It is forbidden to work on/with the joint
cutter as long as any of the above
mentioned damages have occurred and have not
been repaired professionally!
All repair work on the electrics or electronics has to be
carried out by a qualied work-shop!
All repair work on the hydraulics are to be carried
out by a qualied person with special knowledge of
hydraulics!
6.3 Re-greasing and
corrosion protection
The CF-2116 D is, to a great extend, protected against
corrosion! After cleaning and any lengthy lay-off times,
provide the metal sliding parts with a thin coating of
grease (protection against corrosion) or corrosion inhib-
itor oil! All other metal bearings and movable machine
parts should never be allowed to run dry , therefore
must be lightly greased with commercial multi-purpose
grease and machine oil!
Excess oil and grease promote wear due to
clinging dust and cutting mud!
• Check all connections and couplings between the
components! Re-tighten the loosened screw connec-
tions!
6.4 Maintenance and care
of the CF-2116 D engine
ATTENTION!
Read and pay attention to this operational
manual and the operation manual of the
engine!
The engine manual is decisive!
Let any necessary repair work on the engine be carried
out by a qualied work shop or by CEDIMA®!
ATTENTION!
Only use original parts!
Only by using original spare parts or other
recommended spare parts is the operational
security of the CF-2116 D guaranteed!