Cedima CF-2116 D - Table of Maintenance Intervals of the CEDIMA Joint Cutter CF-2116 D

ENGLISH
39
Maintenance and care
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
6.5 Table of maintenance intervals of the CEDIMA
®
joint cutter CF-2116 D
Before each working day
After nishing work
First after 25 h
regularly Weekly
(50 h)
Monthly After
250 h
After 500 h
After 6 months
Yearly (1000 h)
After 4 years
After 6 years
By distur- bances
By damages
Complete machine
3 1 3 3 4***)
Motor (engine oil, lter)
3, 7 7 7*) 7*) 3, 7**) 4***), 7
Hydraulic components (hoses*)
3 3 3 4**) 4**) 3, 4 4
User controls, key, levers, indicators
3 1 3 3 4
Bowden cables, feed, engine
3 1 2 3, 5 4
Tool-holder, ange and blade holder
1, 2 1 3 4
Tool (diamond saw blade)
3, 6 1 3, 4
Securing elements within easy reach (screws and nuts)
3 5 3, 5 4
Hydraulic uid (lifting cylinder)
3 8 4 3, 8 3, 4
Hydraulic uid (feed gear)
3 8 4 3, 8 3, 4
Cooling and rinsing system (lter)
3 1 3 3, 5 4**)
Driving chain (feed)
3 5 3, 5 4**)
V-belt
3 3 4 5, 6 4
Grease points
1, 2
Wheels
3 5, 4**) 4
Battery
3, 8 3, 7, 8 4, 6 3, 4**), 7 4
You will nd the description of the maintenance work in the following and appropriate sections/chapters of this operating manual as well as in the engine’s operating manual of the CF-2116 D. The table can be updated by CEDIMA
®
at any time (e.g. to comply with technical necessities and developments)! Please ask about it at CEDIMA
®
!
1 cleaning, draining 2 lubricants, fats, oils, corrosion protection 3 control (optical, function) 4 exchange, replacing
5 retightening, adjusting, replacing wear parts 6 exchange if necessary 7 maintenance work according to the operating manual (engine and battery) 8 Fluid levels check, replenish
*) more frequent maintenance in dusty surroundings **) dependent upon load, condition, indication ***) depending on th extent of the damage